▪ CANopen Option Card for G3 Operator Interface Terminals
▪ Configured using Crimson software (version 2.0 or later)
▪ Digitally Isolated CANopen Port
▪ Powered and configured from G3 Operator Interface Terminal
▪ Built-in Termination Resistor
▪ Installation and connection hardware included with card

▪ For use with the G3 Series of Operator Interfaces
▪ Protective HMI Overlays for use in Highly Abrasive Environments
▪ Preapplied Low-Tack Adhesive Simplifies Use
▪ 10 Overlays per Package

▪ Adds PROFIBUS DP connectivity to any G3 Operator Interface
▪ Powered by the G3 Operator Interface
▪ Installation and Connection Hardware included with Card

▪ RS232/485 Option Card For G3 Operator Interface Terminals only
▪ Configured using Crimson software (version 2.0 or later)
▪ Isolated RS232 and RS485 Multiplexed ports (capable of communicating with RS232, RS422, RS485, and DH485 devices at up to 115,200 baud)
▪ Powered and Configured from G3 Operator Interface Terminal
▪ Installation and connection hardware included with card

▪ For use with Paradigm Operator Interfaces only
▪ 2 RS232 Ports (for HMI and PC)
▪ Access to PROFIBUS Network thru DB9 Connector
▪ Easily Configured Using EDICT-97 Software
▪ Base or DIN Rail Mount
▪ Status LEDs
▪ Uses Siemens SPC3 ASIC
▪ Automatic Baud Rate Detection from 9.6K Baud to 12M Baud
▪ Freeze Mode and Synch Mode are Supported
▪ Supports Single Indentifier and Special Indentifier Data Area
▪ Descriptions, without Data Consistency Support